To start, i`ve checked a lot of threads and i could not find answer so far.
Nextion enchanced 5.0 changed to 115200 bauds.
Now Arduino Mega changed to Serial1, no matter what i type, they don`t talk.
Non of the supported baud rates work expect for the default 9600.
Which one in theory should be used?
As non of the seems to talk.
Wiring is short circa 10cm. Works ok on 9600.
Does the baud rate must be changed in any of the .h or .cpp files?
An erie silence is heard whistling through the air.
Tumbleweed blows past and cobwebs are everywhere.
You begin to notice almost every thread states:
This forum is closed since Nov 15, 2017
Use the new forum at nextion.itead.cc
it has been open since September 2017.