last night I setup a loop timer and it's not working quite right. I have the switch ON last night
it seemed to ignore the 22:00 "start" and skip right to 5:00 where it turned off, then on, then off, all in 1 minute.
did I do something wrong?
figured it out, it's very unintuitive labeling.
the top section is the repeat interval, and the delay section is how long to do it for.
for instance, if you want it on for 2 hours then off for 1 hour, you'd put 3 hours in the top with Closed, then 2 hours in the Delay with Open.
Thx, Chris helped me figure out on how to set this. The UI is bad. The main screen should have feed back on the LOOP TIMER settings. Anything to show it's going to fire. And the LOOP command is hidden. Have a LOOP icon on the main screen with the Schedule / Timer icons.
30 at restart cycle OFF
check on 25 change status ON
Gets 5 on in a 30 min cycle.